Cavalry-storage CADT-SA2 Manual do Utilizador descarregar pdf (Página 19)

1918

Figure 2.

Step 4. Using a small, flathead

screwdriver, turn the dial to the

appropriate number of the setting you

chose from Step 2. Once you have

done this, lay the unit upright and set

the unit where you would like it to be.

Step 5. Turn the unit on.

Step 6. Press the "Reset" or "Update" button located on the back of the

product (Figure 1.) This will cause the unit to automatically "rebuild" into the

new setting. The "HDD1" and "HDD2" indicator lights will flash while the unit

is rebuilding. This process could take up to 12 hours. Do not move or turn off

the unit while this process takes place. Your unit will be ready to use once

the indicator lights stop flashing.

Step 7. Proceed to Part III to partition and format your newly reconfigured

RAID system.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Sem comentários

Cavalry-storage CADT-SA2 Manual do Utilizador Página 19